Trail-Gear, Inc. introduces a new concept to axle housing design.  This exclusive design features axle tubes that have been offset above the housing centerline.  The inner axles ride near the bottom of the axle tubes rather than in the center.  The results are an increase of  3/8" ground clearance under the axle tubing. Axle tubes are made from ¼” thick DOM tubing.

The heavy-duty, press formed, 1/4" plate steel center section shell is specially shaped to ensure a minimum of 3/4" additional clearance under the differential.  The differential mounting surface is made from ½” plate steel to ensure studs can not pull out, even under heavy loads.  The outer offset flanges are made from 4130 Chromoly to prevent distortion or bending.  Housings are precision alignment checked using start-of-the-art, 3D digital imaging equipment.

The Rock-Assault axle housings use stock or aftermarket 1986-1995 Toyota Pickup/4Runner axle shafts.  An optional fill / inspection cap can be installed for an additional fee.  Additional lengths as well as front applications will be available soon.

Contact Info:

Trail-Gear-Inc.

(877) 4X4-TOYS

(559) 252-4950

5356 E Pine Ave

Fresno, CA 93727

www.Trail-Gear.com