Install the clip on the new axle while it is held securely in a vise (gripped at the very center where there are no splines!). This is the brake side of the axle...

Brush a light coating of grease inside the sprocket and brake rotor hubs.

  Slide the brake rotor hub down against the circlip, then lay a healthy bead of silicon around the outer lip before you run the large axle nuts down and torque then to spec.

Seal the outside of both the sprocket and brake rotor hubs with silicon RTV.

   Now you can bolt on the brake rotor... We chose one from "EBC Brakes" for it's good looks, light weight and greater strength than stock.

   Slide the carrier into the swingarm, drop   the four big bolts into place through the large oval brackets that serve as washers and a guide for chain adjustment (we chromed ours).  Install the rear brake caliper mount (chromed as well) and large snap ring,  feed the axle through the carrier from the right side of the machine.

  Install the sprocket hub in the same way as the rotor hub, using silicon RTV. Followed up with the MONSTER 630 Sidewinder Aluminum Sprocket from Krause Racing...

Krause Racing's 630 sprockets dwarf the stock steel unit!

   TIP: A really big prybar, or extension, etc. stuck through the sprocket, boxed end of the swingarm and the brake rotor will allow you to tighten even the most stubborn of axle nuts.

Blue LocTite (semi-forever)on the chain adjuster studs

   The trick to installing the chain adjuster studs is to lock two nuts together to get the stud threaded down good and tight, use blue LocTite and let it harden over night before you split the nuts apart and install the end plate... Chromed of course!

Red LocTite (forever) on the wheel studs. Super-trick aluminum hubs with steel axle splines are from Dura Blue.

   With the Dura Blue hubs installed we are ready for the wheels and tires We chose ITP's HoleShots and heavy duty reinforced wheels for doing battle in the rocky and rugged terrain that surrounds Las Vegas' city lights... Then the Baja swingarm skid from DG Performance to protect our Krause sprocket and EBC rotor...

Great looks, incredible strength and light weight!

   Well there's the basic rolling chassis! Looks like our Quadzilla is starting to take shape. We have a lot more work before our chassis is fully functional. We still have to bolt on all the brake hardware and steel braided lines, controls cables, wiring, etc. But at least we can roll it around the garage now... And out of Mom's way!

   Join us next month when we get back at the engine and it's reassembly!

Back to Page Three