Our drive shaft kits are also stronger then stock. Our testing shows that a stock drive shaft will twist off and fail at after a maximum load of 3,900 ft/lbs of torque is applied. Our shaft kits test to a maximum of 4,800 ft/lbs of torque. This is accomplished in two ways, first we increase the size of the material both on the inside and outside of the slider section. Then we specially heat-treat the material to increase its strength.

Each kit comes with a heavy duty U-joint installed and tack welded in place to ensure it does not come out on the trail. Cutting and welding required for installation. Long Spline Driveshaft Kits are just $179 each. Free ground shipping included!

Trail-Gear-Inc.
(559) 252-4950
5356 E Pine Ave
Fresno, CA 93727
www.Trail-Gear.com